RC Model Portable Energy Storage Pack
-10°C to 40°C / Dual Output Ports / Built-in Meter / Built to Order
A rugged hard-case power pack with dual front-panel outputs, -10°C to 40°C，operation and tidy labeled wiring — carried like a toolbox, charging two setups at once.
Carry it like a toolbox — molded handle and latches, no separate flight bag needed.
Two front-panel discharge ports let you run or charge two setups at the same time.
A built-in meter shows output voltage at a glance, so no multimeter is needed at the field.
Rated from -10°C to 40°C, covering summer heat and winter cold in the same pack.
Neat, labelled internal wiring makes inspection and service straightforward.
Capacity, output voltage and port layout can be built to your own specification.
- The LIMID RC Model Portable Energy Storage Pack puts a high-capacity battery bank inside a rugged carry case, with the outputs already wired to the front panel. Instead of packing loose packs, a charger and a power supply, you carry one case to the field and plug straight in.
- The molded hard case with a built-in handle and twin latches protects the cells and wiring from impact, dust and splashes during transport. It stacks in a car boot or on a pit table, and needs no additional protective bag.
- Two discharge ports are mounted on the front panel where they can be seen and reached instantly. You can run a charger and a separate load, or two chargers, without opening the case or moving cables around.
- A panel meter reads output voltage directly on the case, so you know the state of the pack before you commit to a charging session. No separate meter, no guesswork about remaining capacity.
- Rated from -10°C to 40°C, the pack keeps working through a winter morning at the slope and a summer afternoon on the tarmac — conditions where an unprotected battery bank would sag or shut down.
- Inside the case, leads are routed, bundled and labelled rather than left loose. That tidiness is not cosmetic: it reduces chafing and connector strain, and makes fault-finding or a cell swap a quick job rather than a full teardown.
- Built for field charging of RC packs and FPV batteries, powering chargers and ground stations far from mains, and for camping, filming and remote-site work where a portable DC source is needed.
- Capacity, output voltage, number and type of output ports, meter type, case size and branding can all be specified. Custom builds are available with samples and volume production.
| Item | Specification | ||
|---|---|---|---|
| Enclosure | Rugged molded hard case with built-in carry handle and twin latches | ||
| Output ports | Two high-current discharge ports, front-panel mounted and clearly marked | ||
| Display | Built-in panel meter showing output voltage | ||
| Charging input | Front-panel charging port with power switch | ||
| Operating temperature | -10°C to 40°C | ||
| Internal wiring | Neat, bundled and labelled harness; serviceable layout | ||
| Capacity / output voltage | Built to order — specified per project | ||
| Customization | Case size, port count and type, meter type, cable length, branding |
