RC Transmitter & Receiver Battery
1S / 2S / 3S / 2200–4400 mAh / 3.7–11.1V / Protected PCB Low Self-Discharge,
Compact cells pack more capacity per gram, slipping into the slim 15–21mm battery bays of most transmitters.Holds its charge through weeks of storage and lasts through many cycles, lowering replacement cost.
High energy density fits more capacity into the slim battery bay of a transmitter.
Low self-discharge keeps the radio ready even after weeks of storage.
Long cycle life outlasts ordinary packs and lowers replacement cost.
A built-in protection circuit guards against over-charge, over-discharge and over-current.
Stable voltage output holds the radio's performance steady to the last percent.
Fast charging returns the pack to service in minimal time between sessions.
- The limid RC Transmitter & Receiver Battery Series is a low-rate, protection-equipped pack purpose-built for RC radios and receiver boxes. It focuses on long standby, safety and a stable voltage curve rather than high current, so the pilot keeps reliable control from power-on to the final landing.
- Using high-energy-density cells, each pack fits more capacity into the narrow 15–21mm battery bays found in popular transmitters, giving longer operating time without bulging the compartment.
- The cells hold their charge through weeks of storage and deliver many charge cycles, so a pack bought today is still dependable next season — lowering lifetime cost for the hobbyist and dealer alike.
- Every pack integrates a protection circuit (PCB) that blocks over-charge, over-discharge and over-current. This keeps both the radio and the battery safe during charge and discharge, with no risk of deep-drain damage.
- Unlike cells that sag under load, these deliver a flat, steady voltage to the radio's electronics, holding stick response, telemetry and range consistent to the last percent of capacity.
- Available in 1S (3.7V), 2S (7.4V) and 3S (11.1V) at 2200–4400 mAh, the series covers single-cell radios, standard 2S transmitters and higher-voltage 3S models — including a flat 65×40×16 variant for tight bays.
- Designed for RC aircraft, helicopter, FPV, car and boat transmitters, plus receiver packs and other low-drain model accessories that need dependable standby power.
- Capacity, cell count, connector (JST / SM / XT30 etc.), wire length, lead position and pack graphics can be customized to your radio model and brand, with samples and volume production.
| Capacity (mAh) | Model | Dimensions L×W×H (mm) | Weight |
|---|---|---|---|
| 2200 | 2S 2200 RX | 100*15*30 | 87g |
| 3S 2200 RX | 100*21*30 | 123g | |
| 2600 | 3S 2600 RX | 65*40*16 | 145g |
| 4400 | 1S 4400 RX | 100*15*30 | 87g |
